Place the lemon on the conveyor belt of the lemon dryer. The lemon is spread on the feeder by the homogenizing device on the conveyor belt.The stacking thickness of lemon is 10-20CM. After the lemon enters the lemon dryer, it runs in an"S" shape in the dryer. The transmission part of the lemon dryer adopts a variable-frequency speed-regulating motor, which can control the internal operation time of the drying according to the difference of the water content of the lemon. The wind speed and wind pressure generated by the hot air blower make the hot air fully and evenly distributed inside the lemon dryer. Because the lower pressure is greater than the upper pressure, the hot air naturally moves upward, passing through each layer of the mesh belt, plus the movement and rolling of the lemon, Make the lemon fully contact with the hot air. fully heat exchange, and improve the drying efficiency. The dried lemon will drain through the last layer.